Installation Guide
Table Of Contents
- ICE MAKER SAFETY
- IMPORTANT SAFEGUARDS
- TECHNICAL INFORMATION
- INTRODUCTION
- COMPONENT LOCATIONS
- ICE MAKER INSTALLATION
- INSTALLATION TYPES
- OPERATION
- MIM50P and MIM50P-O DRAIN SYSTEM OPERATION
- CLEANING AND MAINTENANCE
- CONTROL PANEL
- MAJOR FUNCTIONS
- TROUBLE SHOOTING
- SÉCURITÉ ET MACHINE À GLAÇONS
- MESURES DE PROTECTION IMPORTANTES
- RENSEIGNEMENTS TECHNIQUES
- INTRODUCTION
- EMPLACEMENTS DES COMPOSANTS
- INSTALLATION DE LA MACHINE À GLAÇONS
- Retirer le matériau d’emballage
- Nettoyage avant l’utilisation
- Dégagements pour l’installation
- Exigences en matière d’électricité
- Méthode recommandée de mise à la terre
- Mise de niveau de la machine à glaçons
- Inverser l’ouverture de porte pour MIM50-O et MIM50V
- Inverser l’ouverture de porte pour MIM50, MIM50P et MIM50P-O
- Alimentation en eau
- Outils requis
- Évacuation
- TYPES D’INSTALLATION
- UTILISATION
- FONCTIONNEMENT DU SYSTÈME D’ÉVACUATION MIM50P et MIM50P-O
- NETTOYAGE ET ENTRETIEN
- PANNEAU DE COMMANDE
- FONCTIONS IMPORTANTES
- DÉPANNAGE
- SEGURIDAD DE LA MÁQUINA DE HACER HIELO
- DISPOSICIONES DE SEGURIDAD IMPORTANTES
- INFORMACIÓN TÉCNICA
- INTRODUCCIÓN
- UBICACIONES DE COMPONENTES
- INSTALACIÓN DE LA MÁQUINA DE HACER HIELO
- Quitar los materiales de empaque
- Limpieza antes de usar
- Espacio de separación para la instalación
- Requisitos eléctricos
- Método recomendado de conexión a tierra
- Nivelar la máquina de hacer hielo
- Cómo cambiar el sentido en que abren las puertas de MIM50-O y MIM50V
- Cómo cambiar el sentido en que abren las puertas de MIM50, MIM50P y MIM50P-O
- Suministro de agua
- Herramientas necesarias
- Desagüe
- TIPOS DE INSTALACIÓN
- OPERACIÓN
- OPERACIÓN DEL SISTEMA DE DESAGÜE DE MIM50P Y MIM50P-O
- LIMPIEZA Y MANTENIMIENTO
- PANEL DE CONTROL
- FUNCIONES PRINCIPALES
- SOLUCIÓN DE PROBLEMAS
- Blank Page
- Blank Page
11/07/2017 PK
14
Normal Sounds
Your new ice maker may make sounds that are not familiar to you. Most of the new sounds are normal. Hard surfaces like the
floor and walls can make the sounds louder than they actually are. The following list describes the sounds that might be new to
you and what may be causing them.
•
Rattling noises may come from the flow of the refrigerant or the water line. Item stored
on top of the ice maker can also make noises.
•
The high efficiency compressor may make a pulsating or high-pitched sound.
•
Water running may make a splashing sound.
•
You may hear air being forced over the condenser by the condenser fan.
•
During the harvest cycle, you may hear the sound of ice cubes falling into the ice storage bin.
Preparing The Ice Maker For Long Storage
If the ice maker will not be used for a long time, or is to be moved to another place, it will be necessary to drain the system
of water.
1.
Shut off the water supply at the main water source.
2.
Disconnect the water supply line from the water inlet.
3.
Shut off the electric supply at the main electrical power source.
4.
Take out the ice storage bin to remove any remaining ice and water. Dry the bin.
5.
Pull off the drainage tube of the water trough to drain off all water.
6.
Leave the door open to allow for circulation and to prevent mold and mildew.
7.
Leave water supply line and power cord disconnected until ready to reuse.
NOTE: Do not touch the power plug when your hands are wet. Never unplug the unit by pulling on the cord.
Grasp the plug and pull out firmly.