Use and Care Manual

3
INSTALLATION
BEFORE USING YOUR ICE MAKER
• REMOVE THE EXTERIOR AND INTERIOR PACKAGING MATERIAL.
• CHE
CK TO BE SURE YOU HAVE ALL OF THE FOLLOWING PARTS:
• 1 ICE BUCKET
• 1 ICE SCOOP
• 1 QUICK FITTING [for connecting water supply]
• 1 DOOR LATCH HOOK
• 1 DOOR LATCH BLOCK
• 1 DOOR HANDLE
• 1 INSTRUCTION MANUAL
• BE
FORE CONNECTING THE ICE MAKER TO THE POWER SOURCE, LET IT STAND UPRIGHT FOR
APPROXIMATELY 4 HOURS. THIS WILL REDUCE THE POSSIBILITY OF A MALFUNCTION IN THE
COOLING SYSTEM FROM HANDLING DURING TRANSPORTATION.
• CLEAN THE INTERIOR SURFACE WITH LUKEWARM WATER USING A SOFT CLOTH.
INSTALLING THE HANDLE
This appliance includes a stainless steel handle. To install the handle please follow the below
instructions:
1. Put away the door gasket from the behind, there are two
mounting holes coverer by two caps, take away
the caps, the mounting screws are in the mounting holes.
2. Align the handle with the screws installed. Tighten the screws using a Phillips head screwdriver until
the handle sets both flush and secured tightly against the door frame. (DO NOT over tighten as this will
cause damage to the handle assembly).
3. Recap the mounting holes, and then replace the door gasket to its original position.
4. If you choose not to use the handle supplied, simply follow step 1 to access the installation screws and
remove them and then place the two decorative plugs into the two holes separately. Continue on to step 3 to
replace the door gasket to its original position.