Use and Care Manual

5
We recommend to leave at least 2’’ for the back, ¼’’ for the top and the sides.
REVERSING THE DOOR SWING
THIS APPLIANCE HAS THE CAPABILITY OF THE DOOR OPENING FROM EITHER THE LEFT OR RIGHT
SIDE. THE UNIT IS DELIVERED TO YOU WITH THE DOOR OPENING FROM THE LEFT SIDE (HINGED ON
THE RIGHT).
Tools needed: flathead screwdriver, Phillips screwdriver
IM
PORTANT: Before you begin, make sure the ice maker is unplugged.
1. Ope
n the screw cap on the top hinge and unscrew 3 bolts to take away the top hinge and then lift out the
door.
2. Unscrew the right door latch hook and install the left door latch hook on the opposite side, cover the hinge
holes with the caps, finish the door latch reverse, and put aside.
3. Unscrew to take away the bottom hinge, and then remove the caps in the left of the cabinet and install the
bottom hinge at the left.
4. Install the door on the bottom hinge, and then install the top hinge on the left. Tighten firmly.
ELECT
RICAL CONNECTION
• THIS ICE MAKER SHOULD BE PROPERLY GROUNDED FOR YOUR SAFETY. THE POWER CORD OF THIS
ICE MAKER IS EQUIPPED WITH A THREE-PRONG PLUG WHICH MATES WITH STANDARD THREE PRONG
WALL OUTLETS TO MINIMIZE THE POSSIBILITY OF ELECTRICAL SHOCK.
• DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD GROUND PRONG FROM THE
POWER CORD SUPPLIED.