Crescent Ice maker INSTRUCTION MANUAL Free Standing / Built-in For AUTHORIZED PARTS or TECHNICAL SERVICE, please contact: 1-877-368-2797 or visit Service@MaxxHelp.
IMPORTANT SAFETY INSTRUCTIONS WARNING California Proposition 65 Certain components in this product and its related accessories contain chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. DANGER – Risk Of Fire Or Explosion. FLAMMABLE REFRIGERANT Used. Do Not Use Mechanical Devices To Defrost Refrigerator. Do Not Puncture Refrigerant Tubing. DANGER – Risk Of Fire Or Explosion. FLAMMABLE REFRIGERANT Used. To Be Repaired Only By Trained Service Personnel.
qualified technician perform all other service on the unit. • Children 8 years of age and older and people with reduced physical, sensory or mental capabilities or lack of experience and knowledge can use this appliance if they have been given supervision or instruction concerning use of the appliance in a safe way and they understand the hazards involved. • Never allow children to operate, play with or crawl inside the appliance. • Never allow children to clean and maintain the machine without supervision.
TABLE OF CONTENTS Product Overview and Specs ………………………………………………………..1 - 2 Installation Before Using Your Ice Maker ……………………………………………………………….3 Installing the Handle ………………………………………………………………….......…3 Installation the Ice Maker …………………………………………………………………...4 Reversing the Door Swing …………………………………………………………………..5 Electrical Connection ……………………………………………………………………...5 - 6 Extension Cord ……………………………………………………………………………...6 Connecting the Water Supply …………………………………………………………….....
Product Overview and Specs Model MIMB25C MIM25CO MIM25C Voltage/Frequency AC 115V 60Hz Rated Ice making current 1.9A Rated Ice harvest current 1.5A Refrigerant MIMB25CADA MIM25CADA R600A, 1.58Oz. Indoor/Outdoor Indoor Indoor or Outdoor* Indoor IP Rating - IPX4 - ADA - - Yes Installation Type Working temperature Free standing / Built-in 50 F -100 F 50 F - 90 F Working water pressure 20～120 Psi Ice Storage Capacity 22 lbs. maximum Ice-making Capability at 50°F 25 lbs.
Product Accessories Ice Scoop Left Latch Block Ice Bucket Left Latch Hook 2
INSTALLATION BEFORE USING YOUR ICE MAKER • REMOVE THE EXTERIOR AND INTERIOR PACKAGING MATERIAL. • CHECK TO BE SURE YOU HAVE ALL OF THE FOLLOWING PARTS: • 1 ICE BUCKET • 1 ICE SCOOP • 1 QUICK FITTING [for connecting water supply] • 1 DOOR LATCH HOOK • 1 DOOR LATCH BLOCK • 1 DOOR HANDLE • 1 INSTRUCTION MANUAL • BEFORE CONNECTING THE ICE MAKER TO THE POWER SOURCE, LET IT STAND UPRIGHT FOR APPROXIMATELY 4 HOURS.
INSTALLATION THE ICE MAKER • THE APPLICANCE SHALL NOT EXPOSED TO RAIN EVEN FOR THE MODEL WITH IPX3. • THIS APPLIANCE IS DESIGNED TO VENT HOT AIR THROUGH THE FRONT VENT. THIS ALLOWS FOR INSTALLATION IN A RECESSED OR BUILT-IN APPLICATION, IF DESIRED. • PLACE YOUR ICE MAKER ON A LEVEL SURFACE THAT IS STRONG ENOUGH TO SUPPORT THE ICE MAKER WHEN IT IS FULLY LOADED. REMEMBER THAT THE UNIT WILL BE SIGNIFICANTLY HEAVIER ONCE IT IS OPERATIONAL AND FULLY LOADED.
We recommend to leave at least 2’’ for the back, ¼’’ for the top and the sides. REVERSING THE DOOR SWING THIS APPLIANCE HAS THE CAPABILITY OF THE DOOR OPENING FROM EITHER THE LEFT OR RIGHT SIDE. THE UNIT IS DELIVERED TO YOU WITH THE DOOR OPENING FROM THE LEFT SIDE (HINGED ON THE RIGHT). Tools needed: flathead screwdriver, Phillips screwdriver IMPORTANT: Before you begin, make sure the ice maker is unplugged. 1.
• DO NOT USE AN EXTENSION CORD TO CONNECT POWER TO THE UNIT. • DO NOT USE A TWO-PRONG GROUNDING ADAPTER. • IF YOU ONLY HAVE A TWO-PRONG WALL RECEPTACLE, CONTACT A QUALIFIED ELECTRICIAN TO HAVE IT REPLACED WITH A 3-PRONG RECEPTACLE IN ACCORDANCE WITH APPLICABLE ELECTRICAL CODES. • THIS ICE MAKER REQUIRES A STANDARD 115 VOLTS A.C. 60HZ ELECTRICAL OUTLET WITH THREE-PRONG GROUND.
OPERATING INITIAL START-UP OPERATION 1. PLUG THE APPLIANCE INTO A 115/120V POLARIZED AND GROUNDED WALL ELECTRICAL OUTLET. 2. PLACE THE ON-OFF SWITCH IN THE “I” POSITION. 3. MAKE SURE THE WATER SUPPLY IS ON. AS SOON AS THE INNER MECHANISM REACHES THE PROPER TEMPERATURE, THE ICEMAKER MECHANISM WILL FILL THE MOLD WITH WATER. 4. THE FIRST CUBES MAY BE SMALL BECAUSE OF AIR IN THE WATER LINE. LATER CUBES WILL BE OF STANDARD CRESCENT TYPE SIZE. 5. APPROXIMATE TIME FOR THE FIRST CYCLE IS BETWEEN 30-40 MINUTES. 6.
CAUTION FAILURE TO UNPLUG THE ICE MAKER WHEN CLEANING, MOVING, OR SERVICING IT COULD RESULT IN ELECTRICAL SHOCK OR PERSONAL INJURY. POWER FAILURE MOST POWER FAILURES ARE CORRECTED WITHIN A FEW HOURS AND SHOULD NOT AFFECT THE TEMPERATURE OF YOUR ICE MAKER IF YOU MINIMIZE THE NUMBER OF TIMES THE DOOR IS OPENED. IF THE POWER IS GOING TO BE OFF FOR A LONGER PERIOD OF TIME, YOU SHOULD TAKE THE PROPER STEPS TO DISCONNECT YOUR APPLIANCE. VACATION TIME/STORAGE 1. SHUT OFF THE WATER SUPPLY AT THE MAIN WATER VALVE.
TROUBLESHOOTING GUIDE Before Calling for Service: If the unit appears to be malfunctioning, read through the “Operation” section of this manual first. If the issue persists, check the Troubleshooting Guide below. Some of the problems mentioned in the Troubleshooting Guide can be solved easily without a service call. Problem Possible Cause The ice maker is unplugged. The breaker is tripped. The ice maker doesn’t operate. The water doesn’t feed in after the ice maker starts.
Abnormal Ice, melting or formed together The unit accumulates frost and has to be defrosted often. There is noise during operation. The thermostat may have been adjusted to the highest temperature setting. The ambient temperature is high, or the unit is near a heat source. The door gasket does not seal properly. Power Off. Refrigerant leak. Door isn't properly closed door left open for too long when retrieving ice. High humidity environment The unit may not be leveled and secure.
