Installation Guide

PROBLEM POSSIBLE CAUSE PROBABLE CORRECTION
The machine doesn't
operate
The ice maker is unplugged. Plug the ice maker in.
The fuse is blown. Replace fuse--if it happen, call for
service to check for a short circuit in
the ice maker.
The ice maker power switch
is OFF.
Turn the ice maker power switch
to ON
The ice storage bin is full of ice. Take away some ice, make the ice-
full sensor is free of ice.
The water doesn't feed in
after the ice maker starts.
The water supply tap is turn off. Turn on the water supply tap.
The water supply pipe is not
proper connected.
Reconnect the water supply pipe.
Machine makes ice, but bin
does not ll up with ice
The condenser may be dirty. Clean the condenser.
The air ow to the ice maker
may be obstructed.
Check the installation.
The ambient temperature
and water temperature are
high, or it is near with some
heat resource.
Check the installation.
Water is leaking out the unit.
A few water drops to the
oor when you open the
door to take out ice from
ice storage bin.
Normal condensation on the door or
some water together with ice. Take
care when you take out ice.
Water supply connection leaks. Tighten tting. See Connecting the
water line.
Cubes are partially formed--
are white at the bottom.
Not enough water in
the water bin.
Check if the water supply
pressure is below 15psig.
Check water supply--lter may be
restricted.
Check for a water leak at the water
tank.
Noise during operation
The feet are not leveled. See Leveling the Ice Maker.
Certain sounds are normal. See Normal Sounds.
The icemaker stops suddenly
while making ice.
The electricity is off. Reconnected the power
supply line.
The room temperature is out
the state range.
Cut off the electricity, let the ice
maker stop working till the tempera
-
ture returns within the stated range.
The body of the ice maker is
electried
The earth line isn't in the socket. Please use the socket meeting the
standard.
Scales occur frequently inside
the machine.
The hardness of the water qual
-
ity is too high.
Using a water-soften apparatus
installed in front of the water inlet.
The ice cubes are not
completely formed when
being dumped.
The sprinkler is blocked. Clean the sprinkler, see
"interior cleaning"
17
Troubleshooting Guide