Installation Guide
27
4. Clean
button: W
he
n this button is pressed, the unit enters the Cleaning m
ode. The
green andyellow LEDs flash together. To stop the Cleaning mode, just press the
button again.
5. Mode
button: Main
ly for service. W
hen this button is pressed, unit can change
from
Ice Making m
ode to Ice Harvest m
ode, or fr
om
Ice Harvest m
ode to Ice
Making m
o
de. You can judge the mode from the status of the green and yellow
LEDs.
7. Ice Size Adjustment Guide:
1.) Press and hold the “Adjust” button for at least 3 seconds. The unit will enter
the Ice Size Adjustment mode. The “ICE Making
blinking continuously during the ice size adjustment. Release the button when
the LED blinks continuously to adjust the ice size.
2.) While in the Ice Size Adjustment mode, press the “Clean” button or the
“Mode” button for the desired ice size.
Smaller ice setting
:
By pressing the “Clean” button, you can decrease the size of the ice cubes.
The “ICE FULL” LED (red) will flash as you lower the ice size and will
finally be blinking at the setting of smallest ice size.
Larger ice setting:
By pressing the “Mode” button, you can increase the size of the ice cubes.
The “ICE HARVEST” LED (yellow) will flash as the larger size is set and
will blink when the setting of largest ice size has been reached.
After 10 seconds without any operation, the unit will automatically memorize
the current state and return to the previous mode.
NOTE: Avoid letting water contact the control box.
Major Functions
1.
Com
pletely autom
atic operating procedure.
2. When the ice storage bin is full of ice cubes, the machine stops working
automatically and starts again after the cubes are removed.
3. The different colors of the LED display indicate various work modes.
6. Adjust button: Mainly for service. When this is pressed over 3 seconds, the unit
will enter the Ice Size Adjustment mode. The mode can be judged from the status
of the green LED.
” LED (green) will be
NOTE:
During the ice size adjustment, the “ ICE FULL ”, “ ICE MAKING ” and “ ICE
HARVEST” LEDS blinking all at once indicate that the unit is in the regular (middle)
setting of the ice size.
When the machine is in the cleaning stage or ice full stage, the ice size is not available
for adjusting.
4. Ice cube size is adjustable.