MCWC28 28-Bottle Wine Cellar Cellier pour 28 bouteilles English PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USE INSTRUCTION MANUAL MODE D’EMPLOI Be sure wine cellar is standing upright 24 hours prior to plug-in.
IMPORTANT SAFEGUARDS Read all instructions before using this appliance. When using this appliance, always exercise basic safety precautions, including the following: 1. Use this appliance only for its intended purpose as described in this instruction manual. 2. This Wine Cellar must be properly installed in accordance with the installation instructions before it is used. See grounding instructions in the Installation section. 3. This model can be built in or free-standing.
TECHNICAL SPECIFICATIONS
INSTALLATION Remove the exterior and interior packaging. Use a soft dry cloth to wipe down the outside of the wine cellar thoroughly. Use a clean cloth dampened with lukewarm water to wipe down the inside of the cellar. The cellar should be located in a well-ventilated area. Avoid placing it near any source of heat or moisture, or in direct sunlight. Direct sunlight may affect the finish, and nearby heat sources will cause higher electrical consumption.
OPERATING YOUR WINE CELLAR IMPORTANT: Do not plug in the wine cellar for 24 hours after unit is set in place. Failure to do so may result in the unit working improperly. Plug in the wine cellar to turn it on automatically. (After the unit has been on for about 6 hours, the compressor will shut down for thirty minutes to allow for automatic defrosting.) If you want to use the Automatic Temperature (default) setting, do nothing further.
OPERATING YOUR WINE CELLAR Memorized Temperature Setting The unit has been designed to “remember” the last run mode to which it was set. If there is a power outage or any other power cutoff, the unit will automatically return to the previous temperature setting after power is returned. Compressor Run Indicator The compressor is running when the unit displays a moving icon representing a running fan. If the compressor stops running, the icon will stop moving as well.
CLEANING & MAINTENANCE Cleaning the Outside Clean the outside of your unit with mild soapy water. Dry thoroughly with a soft cloth. To clean the door gasket, use only mild soapy water. Never use harsh cleansers or scouring pads to clean any part of your wine cellar. Cleaning the Inside Unplug your wine cellar and remove all bottles. Wipe the inner surfaces with a soft, clean cloth dampened with plain water. Dry the chrome trays.
CELLAR TROUBLESHOOTING Cellar does not turn on Not plugged in. Fuse blown or circuit breaker tripped. Noise or vibration Check that unit is level. If not, adjust leveling legs. Cellar is too warm Check that door is properly closed and sealed. Check temperature setting. (To change the temperature setting, follow the steps in the Operating Your Wine Cellar section of this manual.) Check if door has been opened frequently. LCD displays “PROBE ERROR - E” This message is an ALARM MODE indication.
9
