Use and Care Guide

9
Caution: Damages caused by ambient temperatures of 40°F (4℃) or below are
not covered by the warranty.
To temporarily stop the cooling cycle, unplug the Refrigerator. To shut it down for
longer periods of time, disconnect the plug and leave the door partially open.
NOTE: If you unplug the Refrigerator, allow 3 minutes before plugging it back in.
The unit will not restart in less than 3 minutes.
Memorized Temperature Settings
Your unit has been designed to “remember” the last run mode to which it was set.
If there is a power outage or any other power cutoff, the unit will automatically
return to the previous temperature setting after the power has returned.
Compressor Run Indicator
When the compressor is running, the control panel will light a running LED light
representing a running compressor. If the compressor stops running, the running
LED will go out as well.
ALARM Mode
In the event that there is a fault in the unit, an ALARM LED light will appear on the
control panel.
In ALARM mode, the unit will make a beeping sound and display an alarm
message. If the control panel displays any of the following messages: EI, HI or LI,
consult the Troubleshooting section of this manual.
Interior Light
The interior light can be turned On or Off automatically with the opening or closing
of the door.
Shelving
The unit has 3 adjustable chrome-plated flat wire shelves to hold cans and bottles
of beverages such as beer, water and soft drinks.
These racks are designed to only be pulled out 1/3 of the way. This is a safety
feature so that neither the machine nor the shelf will tip over.
The racks are removable and reversible. To remove a rack, take out the cans on
the rack and pull it out until it stops. Then lift up the front of the rack and remove it
from the unit.