Use and Care Manual

5
Remove the exterior and interior packaging. Use a soft dry cloth to wipe down the
outside of the refrigerator thoroughly. Use a clean cloth dampened with lukewarm
water to wipe down the inside of the refrigerator.
Air must circulate freely in front of the refrigerator. Avoid placing the appliance
near any source of heat or moisture, or in direct sunlight. Direct sunlight may affect
the finish, and nearby heat sources will cause higher electrical consumption.
The Refrigerator is designed to be either free-standing or built-in. It has motorized fans
at the back of the unit that direct compressor-generated heat away from the com-
pressor and through the front of the unit, keeping the front vents unobstructed. If the
unit is built-in, allow minimum clearances of 1/4” at the sides, 1/2” at the back and 1”
at the top.
Reversing the Door Swing
Tools needed: Flathead screwdriver, Phillips screwdriver
IMPORTANT: Before you begin, unplug the refrigerator or disconnect power.
To remove door from hinges:
1. Remove the top hinge cover and bottom louver.
2. Using a Phillips screwdriver, remove the screws, then remove top hinge mat and
top hinge. Keep the parts together and set them aside.
3. Lift the door off the bottom hinge and turn it upside down so that the handle is on
the right. Set the door aside.
4. Using a flat screwdriver, remove the four plug buttons from the screw holes on the
INSTALLATION
Top hinge
Bottom hinge
Bottom louver
Plug buttons
Magnet baffle
Door switch baffle
u
l
P
e
ng
i
h
op
T
s
on
tt
bu
ug
e
ng
i
h
m
o
tt
o
B
e
l
ff
ba
t
e
n
ag
M
ba
h
c
t
i
w
s
r
oo
D
m
o
tt
o
B
e
l
ff
a
r
ouve
l