Installation Guide

1. This unit must be properly installed in accordance with the installation instructions
before it is used. See grounding instructions in the Installation section.
2. This model can either be built-in or free-standing. Built-in units vent at the bottom
front and airflow at the front of this vent must be unimpeded.
3. Install the unit in a location where the floor is sturdy enough to support the load of
the unit. If the floor is not sturdy enough or installation is incorrectly performed, the unit
could tip over and cause personal injury. If the unit is placed on a stand, the front sur-
face must be 3” or more back from the edge of the stand in order to avoid accidental
tipping of the appliance during normal usage.
4. Never place heavy objects or items containing water on top of the unit. Objects
could fall and cause injury and spilled water could cause the deterioration of the insu-
lation of electrical components and result in electrical shock.
5. Disconnect the unit if it is behaving abnormally, and do not reconnect until the sit-
uation is corrected.
6. Pull out the plug before doing any maintenance on the unit to avoid electric shock.
7. Never pull out plug when hands are wet!
8. This unit is not intended for the storage of medicines or chemical reagents.
9. Keep packing materials away from children.
10. Condenser water from evaporator drains into a hole in the floor of the storage com-
partment and is channeled into a drain pan located at the back of the unit on the
compressor. Heat transferred from the compressor evaporates any water that has col-
lected in the pan. Be sure the drain hole in the floor of the unit is clear and unob-
structed.
11. During long absences, remove the unit’s contents, unplug the unit, clean it and
leave the door open slightly to avoid possible formation of condensation, mold or
odors. Use a cover to protect the unit and prolong its lifespan.
12. Leave disassembly and disposal of the unit to qualified experts.
SAVE THESE INSTRUCTIONS!
DANGER!
Avoid the risk of child entrapment. If product is not in use, remove the door so that small
children cannot get trapped inside.