Use and Care Manual

Ventamatic, Ltd. P.O. Box 728, Mineral Wells, TX 76068-0728 1-800-433-1626 Fax: 940.325.9311 www.BVC.com
2
Assembly and Operation
MOUNTING THE FAN SUPPORT HOUSING ON
PEDESTAL
Attach BRACKET POST (4) to BASE (1) with 4 screws
and spring washers (2) as shown, tighten securely.
Loosen the PLASTIC ROUND NUT (5) on the
BRACKET POST (4) and extend the INNER TUBE (6)
to the desired height.
Slide the COVER RING (3) down onto the STAND
POST (4) and lay it on top of the BASE (1).
THE PLASTIC ROUND NUT (5) must be fully tightened
before assembling the MOTOR (8) to the INNER TUBE
(6).
ENGINE AND SUPPORT STATION MOUNTING
INSTRUCTIONS
Locate the MOTOR (8) and insert it into the INNER
TUBE (6).
Align hole in INNER TUBE (6), tighten screw and
washer (7) SECURELY.
Attach two 3-WING PLASTIC KNOBS (9) to the
EORZHUWRDGMXVWWKHDLUȵRZDQJOH
TO ADJUST AIR FLOW ANGLE:
Tilt the fan head to the desired angle by loosening THE
.12%WKHQWLJKWHQLWȴUPO\
SPEED CONTROL:
Turn the SWITCH to OFF (0), HIGH (3), MEDIUM (2) and
LOW (1) speeds for the respective air speed.
CLEANING:
Unplug it from the power source before cleaning it.
After maintenance, all safety devices (including
ORXYHUVDQGEODGHVPXVWEHUHLQVWDOOHGRUȴWWHGDV
previously installed.
Use a soft, damp cloth to clean. Then clean it with a
dry cloth.
Do not use cleaning solutions that are harmful to
paints or plastics.
Do not bend the blades.
The motor bearings are permanently sealed and do
QRWUHTXLUHDGGLWLRQDOOXEULFDWLRQ
This product is not intended for use by persons
(including children) with reduced physical, sensory or
mental capacities, or lack of experience and knowledge,
unless they have been supervised or instructed in the
use of the product by a person responsible for their
safety. . Children should be supervised to ensure that
they do not play with the product.
If the power cord is damaged, it must be replaced by
WKHPDQXIDFWXUHULWVVHUYLFHDJHQWRUVLPLODUO\TXDOLȴHG
persons to avoid any danger.
WARNING
WARNING
CAUTION
2
3
4
5
6
7
1
8