30” OSCILLATING WALL MOUNT FAN MODEL HVWM 30 OSC 30” NON-OSCILLATING WALL MOUNT FAN MODEL HVWM 30 OWNER’S MANUAL READ & SAVE THESE INSTRUCTIONS HRD INS 30WM REV. 12/8/20 .
ASSEMBLY AND OPERATING INSTRUCTIONS CAUTION: Read and follow all instructions before operating fan. Do not use fan if any part is damaged or missing. WARNING: To reduce the risk of fire or electrical shock, do not use this fan with any solid state speed control device. This appliance has a 3-prong plug. To reduce the risk of electrical shock, this plug is intended to fit in an outlet only one way. If this plug does not fit the outlet, contact a qualified electrician.
4. 5. Secure with the (4) M5x15 screws and flat washers that were removed in Step 2. Slide the FAN BLADE onto the motor shaft until the front of the FAN BLADE is flush with the shaft end. Use the provided hex wrench to tighten the SET SCREW onto the flat portion of the motor shaft. Caution: Do not alter the angle of the blades. FRONT GUARD ASSEMBLY 1. Align front and rear grilles. Slide zip tie through top hole of front grille and top hole of rear grille. Tighten zip tie to secure grilles together. 2.
LIMITED WARRANTY This warranty is underwritten by Falco Insurance Company and is extended to the original retail purchaser of this model or, if this unit is purchased and requires installation by a building contractor, to the original owner of the home. No subsequent purchaser of the unit or of a home in which it is installed is entitled to any of the benefits of this warranty.
