Instructions / Assembly

FOR INSTALLATION BEHIND TRIANGULAR GABLE VENTS
For installation on triangular gable vents, refer to steps 1-3 on the opposite page and the following
illustrations for references.
Step 1 Step 2 Step 3
THERMOSTAT INSTALLATION
WARNING
• Before wiring the thermostat, turn the power off at the breaker to avoid electrocution.
• Be certain to confirm to all Local Electric Codes and Regulations.
• Remove the cover from the thermostat box and use screws to attach the mounting plate to a stud.
• When installing the thermostat box, use screws to attach it to the stud to prevent damage to the control.
• Leave the back side of the control unobstructed to allow free air circulation behind the box.
• Wire the unit to the incoming power supply according to the diagram below.
• The thermostat is adjustable. Recommended setting is 90-110 degrees F depending on local
temperatures.
• The fan will run as long as the attic temperature remains above the set temperature.