User Manual

PS2 RF900M JOYPAD
USA Version
15.1.2003
~ 2 ~
Key definition (program function) – The program button allows users to fully customize the
digital buttons to fit their own operating habit. It changes the mapping of the physical button to
another button as described below.
Programming procedure
1) Push “program” button
2) Push button (Button_1) to be programmed
3) Push button (Button_2) that you want to be programmed
Button_1 is now programmed as Button_2
LED’s – RECEIVER Unit
The GREEN LED flashes when valid data is received. This LED should flicker at a constant rate on
a functional product while it is within range and on a channel with no RF noise. If this LED is OFF
for extended periods of time then the RF link is not solid (due to range or noise). Try moving closer
or moving to a different channel.
LED’s – WIRELESS PAD Unit
The RED LED is Off for Digital Mode, On for Analog Mode.
Power Selection Options
1. Power Switch – in this configuration the power switch turns the power ON & OFF.
16 Channels For US Version
Different channels are required when using multiple Peripheral-Link sets side by side, or in the
unlikely event that a channel is noisy. Channel selection (using DIP4 switches ON or OFF) 16
combinations are possible.
Modifications not authorized by the manufacturer may void users authority
to operate this device.
NOTE:
This equipment has been tested and found to comply with limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio communications.
However, these is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or