Product Manual

20
 Release the trigger to stop water flow.
WASHING / CLEANING
 Firmly grip the spray gun with both hands.
 Point the nozzle to a safe direction and squeeze the spray gun trigger to allow the pump to
purge air and impurities in the system and then redirect the nozzle to the working surface.
 When finished, release the gun trigger to stop water flow.
USAGE TIPS
 For most effective cleaning, keep the spray nozzle 8 to 24 inches away from the cleaning surface.
 If you get the spray nozzle too close, especially using the high
pressure mode, you may damage the surface being
cleaned.
 DO NOT get closer than 6 inches when cleaning tyres.
PRESSURE ADJUSTMENT
Increase distance: To vary the pressure on the surface being cleaned, vary the distance between the
spray wand and the surface being cleaned.
Change pressure wand nozzle: Completely shut down the pressure washer and stop the engine.
Change the spray nozzle for desired pressure (see “selecting the right nozzle”).
Restart engine.
Adjust pump pressure regulator: The pump pressure regulator allows
pressure adjustment at the pump. Turn the pressure regulator knob on
pressure pump counter clockwise/clockwise to decrease / increase pressure.
USING CHEMICALS AND CLEANING SOLVENTS
Use only soaps and chemicals designed for use with the pressure washer. DO NOT use chlorine bleach.
Chemicals, soaps and cleaning solvents will not siphon when a high pressure is used. Use the chemical
nozzle (black).
TO APPLY DETERGENT:
 Prepare detergent solution as recommended by the manufacturer.
 Remove the detergent tank lid located in front of the pressure washer.
 Fill the tank with prepared detergent solution. A small funnel may help with this task. Replace
the detergent tank lid.