Product Manual
Table Of Contents
- IMPORTANT:
- IMPORTANT NOTICES:
- 6. CONTROLS AND FEATURES
- 8. ELECTRICAL CONNECTION:
- 8.1 CAPACITY:
- 8.2 POWER MANAGEMENT:
- To prolong the life of your generator and attached devices, follow these steps to add an electrical load:
- 8.3 CONNECTING ELECTRICAL LOADS:
- 8.4 PARALLEL CONNECTION WITHIN 2 GENERATORS:
- 8.5 BATTERY CHARGING:
- 9.1 PERIODIC MAINTENANCE:
- 9.3 ENGINE OIL REPLACEMENT
- 9.4 AIR FILTER MAINTENANCE
- 9.5 FUEL FILTER MAINTENANCE
- 9.6 DRAINING FUEL TANK/CARBURETOR
- 10.TROUBLESHOOTING:
- BELOW IS A LIST OF GENERATORS THAT ARE COVERED UNDER THIS WARRANTY:
- BELOW IS A TABLE OF PARTS THAT ARE LIMITED BY THIS WARRANTY
- DISCLAIMER OF CONSEQUENTIAL DAMAGE AND LIMITITATION OF IMPLIED WARRANTIES
- ONLINE ORDER RETURNS POLICY
- DAMAGED IN TRANSIT
- NOT AS ADVERTSIED /INCORRECT ITEM
- FAULTY PRODUCT
- CHANGE OF MIND
- VALIDRECEIPT
34
②
①
9.2 SPARK PLUG MAINTENANCE:
The spark plugs in an important engine component and should be
checked periodically.
1. Remove the screws 1 and then remove
the cover 2.
2. Remove the spark plug cable from the
spark plug.
3. Use the spark plug tool that shipped with your generator
to remove the plug
.
4. Inspect the elect rode on the plug.
It must be clean and not worn to
produce the spark required for
ignition.
5. Make certain the spark plug gap is 0.7-0.8mm or
(0.028-0.031in).
A
B
A - Spark plug
B - Spark plug cap
6. Refer to the spark plug recommendation chart when replacing the plug.
7. Carefully thread the plug into the engine.
8. Used the spark plug tool to firmly install the plug.