Product Manual
Table Of Contents
- IMPORTANT:
- IMPORTANT NOTICES:
- 6. CONTROLS AND FEATURES
- 8. ELECTRICAL CONNECTION:
- 8.1 CAPACITY:
- 8.2 POWER MANAGEMENT:
- To prolong the life of your generator and attached devices, follow these steps to add an electrical load:
- 8.3 CONNECTING ELECTRICAL LOADS:
- 8.4 PARALLEL CONNECTION WITHIN 2 GENERATORS:
- 8.5 BATTERY CHARGING:
- 9.1 PERIODIC MAINTENANCE:
- 9.3 ENGINE OIL REPLACEMENT
- 9.4 AIR FILTER MAINTENANCE
- 9.5 FUEL FILTER MAINTENANCE
- 9.6 DRAINING FUEL TANK/CARBURETOR
- 10.TROUBLESHOOTING:
- BELOW IS A LIST OF GENERATORS THAT ARE COVERED UNDER THIS WARRANTY:
- BELOW IS A TABLE OF PARTS THAT ARE LIMITED BY THIS WARRANTY
- DISCLAIMER OF CONSEQUENTIAL DAMAGE AND LIMITITATION OF IMPLIED WARRANTIES
- ONLINE ORDER RETURNS POLICY
- DAMAGED IN TRANSIT
- NOT AS ADVERTSIED /INCORRECT ITEM
- FAULTY PRODUCT
- CHANGE OF MIND
- VALIDRECEIPT
26
8.2.3 Plug in and turn on the first item, it is best to attach the item with
the largest load first.
8.2.4 Allow the generator to stabilize.
8.2.5 Plug in and turn on the next item.
8.2.6 Repeat steps 5-6 for each additional item.
8.3 CONNECTING ELECTRICAL LOADS:
8.3.1 Let the engine stabilize and warm up a few minutes after starting.
8.3.2 Prior to powering tools and equipment make sure that the
generators rated voltage, and amperage capacity is adequate to
supply all the electrical loads that the generator will power.
(230V,7amps,12V DC @ 8 Amps)
8.3.3 Once the generator is running, simply connect the [power cords of
230V AC equipment into the AC outlets.
8.3.4 DO NOT connect 3-phase loads to the generator.
8.3.5 DO NOT overload the generator.
NOTE: The DC terminals may be used for charging 12 Volt automotive type
batteries only.