Product Manual
Table Of Contents
- IMPORTANT:
- IMPORTANT NOTICES:
- 6. CONTROLS AND FEATURES
- 8. ELECTRICAL CONNECTION:
- 8.1 CAPACITY:
- 8.2 POWER MANAGEMENT:
- To prolong the life of your generator and attached devices, follow these steps to add an electrical load:
- 8.3 CONNECTING ELECTRICAL LOADS:
- 8.4 PARALLEL CONNECTION WITHIN 2 GENERATORS:
- 8.5 BATTERY CHARGING:
- 9.1 PERIODIC MAINTENANCE:
- 9.3 ENGINE OIL REPLACEMENT
- 9.4 AIR FILTER MAINTENANCE
- 9.5 FUEL FILTER MAINTENANCE
- 9.6 DRAINING FUEL TANK/CARBURETOR
- 10.TROUBLESHOOTING:
- BELOW IS A LIST OF GENERATORS THAT ARE COVERED UNDER THIS WARRANTY:
- BELOW IS A TABLE OF PARTS THAT ARE LIMITED BY THIS WARRANTY
- DISCLAIMER OF CONSEQUENTIAL DAMAGE AND LIMITITATION OF IMPLIED WARRANTIES
- ONLINE ORDER RETURNS POLICY
- DAMAGED IN TRANSIT
- NOT AS ADVERTSIED /INCORRECT ITEM
- FAULTY PRODUCT
- CHANGE OF MIND
- VALIDRECEIPT
18
7.2 ADDING THE ENGINE OIL:
The generator has been shipped without engine oil.
DO NOT add fuel or start the engine before adding engine oil.
Attempting to start the generator without the correct amount of engine
oil will result in equipment failure.
Engine oil has a major influence on engine performance and service life. For
general, all-temperature use, SAE 10W-30 is recommended. Always use a 4-stroke
engine oil that meets or exceeds the requirements.
NOTE: Non-detergent or 2-stroke engine oil will damage the engine and should
not be used.
n Loosen the screws at the side of the left maintenance cover. Remove cover and
set aside.
n Unscrew the oil cap/dipstick and remove.
n Wipe dipstick clean and re-seat in hole; do not re-thread.
n Remove dipstick again and check engine oil level. Engine oil level should fall
between the minimum and maximum marks on the dipstick.
n If level is low, add engine oil.
n Replace and secure the cap/dipstick.
Place the generator on a level surface.
DO NOT tilt the generator while adding oil. It
can cause you to overfill the oil and or cause
the oil leak into areas in which it is not