Product Manual
TO S TART T H E ENGINE
1. Disconnect all loads to the generator. Turn off the master switch to ensure that no
electrical current is connected to the generator.
2. Turn the fuel valve lever to the ON posi
n. Wait for a minute for the fuel to enter the
carbure
or (for first me use).
3. For cold engines, move choke lever to full choke posi
on. To restart a warm engine,
move choke lever to half choke or to RUN posi
on.
ENIGNE TRATS OT TRATS YEK GNISU
1. Turn the engine switch to the START posi
on and hold it there un l the engine starts.
Note that when the motor is started for the very first
, it may require a number of
a
empts to start un the fuel has travelled from the tank to the motor.
2. Once you hear the engine operang, release the key to allow the posi
on to move from
START to ON posi
n.
3. Move the choke lever back to RUN posi
on.
TRATS LIOCER GNISU
1. Using recoil start to start the engine – turn the engine switch to the ON posi
n. Pull
the starter grip lightly un
you feel the resistance, then pull the start cord out briskly
and rapidly. Allow start cord to return slowly.
isop NUR eht ot ylwols revel ekohc eht evom ,strats enigne ehtnehW .2
on.
3. Under long, c
ous-run opera ng condi ons, be prepared to check the fuel level
through the fuel gauge on the top. Never refuel when the generator is in opera
n.