Operation Manual

MOUNTING OPTIONS
Case
Suction stand
Wall mount
G-clamp
The system can be used
in its case, placed
directly on the ground
or on a table.
The antenna can also be
simply placed on a flat
smooth surface such as
painted vehicle body panels.
The wall mount can be fixed
to any types of strong wall.
Can be used to mount to
masts, caravan jockey
wheels, lorry wing
mirrors etc.
Installation of suction stand on horizontal surface
■
Place the suction foot (1) onto a smooth, clean and even surface,
e. g. your car roof .
■
Moisten suction feet to improve suction force
■
Tighten the three screw plugs (2) in a clockwise direction. This generates
a vacuum at the rubber seats, which fixes the suction foot onto the surface.
■
Insert the supporting arm with attached dish and LNB
(see LNB installation section 1) into the mounting hole of the suction foot.
■
Tighten the wing nut on the suction foot (3).
IMPORTANT - Maxview do not recommend verticle
installation with the use of the suction stand
Installation in a case
■
Open the lid of the case and tighten the wing nut to secure it
■
Ensure antenna is secured to the case
■
Insert the support arm (1) with LNB into the opening of the antenna (2)
Installation of LNB and LNB arm
■
Loosen the screws on the LNB bracket (3).
■
Insert LNB (2) in the LNB bracket (1) as shown
■
Tighten the screws of the LNB bracket slightly.
■
Insert the LNB bracket into the supporting arm (4).
■
Tighten the screws of the LNB bracket.
■
Insert the supporting arm into the antenna (5)
NB - Adding some weight in the box will help balance
the dish and stop any wind tipping it over
WARNING -
If you have mounted the antenna on a vehicle roof,
you must dismantle it before travelling.
2
3
1
Installation on a mast with G-clamp
■
Attach G-clamp (1) onto a mast
■
Insert the extension rod (2) in the mounting hole of the G-clamp and
tighten wing nut
■
Insert the supporting arm with attached dish and LNB
(see LNB installation section)
■
Tighten the wing nut on the extension rod
IMPORTANT - Not for permanent fixing
WARNING - Always follow manufacturer’s operating and safety
instructions before using power tools and/or equipment
WARNING - Make sure all the dish parts and G-clamp
are tightly and properly secure
Installation on a wall with the wall mount
■
Place the wall bracket (1) at a position, where it should be installed
■
Mark the position of four fixing holes, drill the four holes and insert wall plugs
■
Position the wall bracket and tighten it with four screws
■
Insert the extension rod in the wall bracket
■
Insert both coach bolts through the wall bracket
■
Fasten nuts on the coach bolts and tighten until the extension rod is fixed into
the wall bracket
■
Insert antenna assembly into extension rod and tighten wingnut (3)
4
5
Installation on a balcony with G-clamp
■
Attach G-clamp (1) on balcony
■
Insert the supporting arm with attached dish and LNB
(see LNB installation section 1)
■
Tighten the wing nut on the extension rod
IMPORTANT INFORMATION
-
Please use this product responsibly
- Keep away from children and animals
- Take care not to cause obstruction with the antenna and cable
- Do not position the system where it could fall and cause injury
- This product is supplied with a 2 year warranty.
It does not cover faults caused by incorrect installation or misuse
GENERAL SET UP GUIDE