Installation guide

PAGE 6 - ENGLISH
MAXTOR SATA/300 PCI CARD
INSTALLATION GUIDE
Connecting a SATA Hard Drive
Each of the two SATA/300 ports on the SATA/300 PCI Card supports a single SATA hard drive. To connect a SATA drive
to the card:
1. Attach one end of a SATA interface cable to one of the SATA connectors on the card. (See Figure 5 on page 5.)
2. Attach the other end of the SATA interface cable to the SATA connector on the rear of the hard drive.
SATA Interface
Connector
Power
Connector
POWER
SATA
NC
no connect
Force 150
transfer speeds
Note: The NC jumper pins have no
function. They are used only for
spare jumper storage.
The Force 150 jumper should be in
the NC position when the drive is
connected directly to the Maxtor
SATA card.
FIGURE 6
ATTACHING CABLES TO SATA DRIVE