Installation guide

ENGLISH - PAGE 7
MAXTOR SATA/300 PCI CARD INSTALLATION GUIDE
Connecting an Ultra ATA Hard Drive
The SATA/300 PCI Card has one Ultra ATA/133 port that supports up to two Ultra ATA/IDE hard drives on a single
80-conductor, 40-pin Ultra ATA cable
(sold separately) . The card does not support ATAPI devices such as Zip drives or
CD/DVD drives
. For maximum compatibility and data integrity, Maxtor strongly recommends that you do not use older
40-conductor ATA/IDE cables with this card.
1. Configure the jumpers of the Ultra ATA hard drive to the cable select setting. If you are connecting two Ultra ATA
drives, they should both be configured to the cable select (CS) setting. Consult the drive label, documentation, or
manufacturer for jumper configuration information. Jumper settings for popular Maxtor models are shown below
in Figure 7.
Cylinder
Limitation
Jumper (CLJ)
(not for use
with this card)
Style B
(Includes DiamondMax
Plus 8 and Fireball 3)
Style C
(Models D740X-6L
and D540X-4K)
Cable
Select
Slave
Master
Style A1
(Includes
DiamondMax 16)
Cable
Select
Slave
Master
Style A2
(Includes DiamondMax
Plus 9, 10 or 11)
FIGURE 7
JUMPER BLOCK POSITIONS