Technical data

Installation
DiamondMax 10 80/100/120/160/200/250/300GB Serial ATA 3-7
Table 3-1 Device plug connector pin definition
Signal
segment
S1 Ground 2
nd
Mate
S2 A+ Differential signal pair A from Phy
S3 A-
S4 Ground 2
nd
Mate
S5 B- Differential signal pair B from Phy
S6 B+
S7 Ground 2
nd
Mate
Signal Segemnt “L”
Central Connector Polarizer
Power Segment “L”
Power
segment
P1
P2
P3
P4 Ground 1
st
mate
P5 Ground 2
nd
mate
P6 Ground 2
nd
mate
P7 V
5
5V power, pre-charge, 2
nd
mate
P8 V
5
5V power
P9 V
5
5V power
P10 Ground 2
nd
mate
P11 Staggered
Spin/LED
1. Pin 11, before PHY initialization, is used to de-
tect staggered spin up. If Pin 11 is grounded Drives
spin up on power. If Pin 11 is no-connect, the
drive will not spin up until host initiates the PHY
initialization routine.
2. Pin 11, after PHY initialization, is used for driv-
ing LED Activity. The device provides a low volt-
age-current driver to drive the LED activity signal.
P12 Ground 1
st
mate
P13 V
12
12V power, pre-charge, 2
nd
mate
P14 V
12
12V power
P15 V
12
12V power
Power Segment Key