Specifications

Chapter #2 - Overview - MaxAttach NAS 6000 Hardware 34 000001628
MaxAttach NAS 6000 Administration Guide
Chapter #2 - Overview - MaxAttach NAS 6000 Hardware
Description of System Components
11/07/01 -- Revision 2.0.03A
Optionally, an administrator can modify the default RAID configuration and leave one or
two drives available as hot spare drives. These are drives that are powered up, but unused in
any array. In the event of a drive failure, the failed drive drops offline and is replaced
automatically by the hot standby drive. The RAID rebuild process starts automatically and
immediately.
Figure #15 Hot Swappable Hard Disk Drive Carrier Diagram and Photo
CPU I/O Panel
The CPU I/O Panel is located on the Base Unit’s Back Panel and it is the primary
diagnostic and administration interface into the MaxAttach NAS 6000.
Figure #16 CPU I/O Panel Above the EMU Connector Panel
It provides connections for: