Specifications

Chapter #14 - Appendix - Disk Array Error Codes 285 000001628
MaxAttach NAS 6000 Administration Guide
Chapter #14 - Appendix - Disk Array Error Codes
Mylex Error Codes Table
11/07/01 -- Revision 2.0.03A
47 47 1 Serious A hard disk failed because device was not found on start up.
48 48 1 Serious A hard disk failed because write operation of the ‘Configuration On Disk’
failed.
49 49 1 Serious A hard disk failed because write operation of ‘Bad Data Table’ failed.
50 50 3 Warning Physical device status changed to offline.
51 51 3 Warning Physical device status changed to Hot Spare.
52 52 3 Warning Physical device status changed to rebuild.
53 53 3 Warning Physical device ID did not match.
54 54 3 Warning Physical device failed to start.
55 55 3 Warning Physical device negotiated different offset than config.
56 56 3 Warning Physical device negotiated different bus width than config.
57 57 1 Serious Physical drive missing on startup.
58 58 3 Warning Rebuild startup failed due to lower disk capacity.
59 59 3 Warning Physical drive is switching from a channel to the other channel.
60 60 2 Error Temporary-Dead physical drive is automatically made online.
61 61 4 Information A standby rebuild has started.
96 96 1 Serious Device Loop Id Conflict (Soft Addressing) Detected.
128 128 4 Information Consistency check is started.
129 129 4 Information Consistency check is finished.
130 130 4 Information Consistency check is cancelled.
131 131 2 Error Consistency check on logical drive error.
132 132 2 Error Consistency check on logical drive failed.
133 133 4 Information Consistency check failed due to physical device failure.
134 134 1 Serious Logical drive has been made offline.
135 135 2 Error Logical drive is critical.
136 136 4 Information Logical drive has been placed online.
137 137 4 Information An automatic rebuild has started on logical drive.
Table #1 - Mylex Error Codes (Sheet 3 of 8)
Gam_ev
ent
Number
User_ev
ent
Number
Priority
Number
Severity
Level
Description