Specifications

Chapter #1 - Installation - Rack Mounting Your NAS 6000 5 000001628
MaxAttach NAS 6000 Administration Guide
Chapter #1 - Installation - Rack Mounting Your NAS 6000
1: User-Supplied Materials and Services
11/07/01 -- Revision 2.0.03A
Cabinet-Mount System or Single Base Unit Rack Mount System
1. Process Branch Point:
n If your system has a Base Unit and one or two Expansion Units, perform the
next step in this process immediately below in the section titled SCSI
Connections Between Base Unit and First Expansion Unit on page 5.
n If you have a cabinet-mounted stem or a single Base Unit rack-mount system,
no SCSI cabling is required. Skip ahead below to the section titled Install
EMU Cables on page 7.
Figure #3 NAS 6000 SCSI Cable Connections
SCSI Connections Between Base Unit and First Expansion Unit
2. Connect a SCSI cable from the Mylex upper left Port 0 connector to the right side
SCSI Connector Board.
3. Connect a second SCSI cable from the Mylex upper right Port 1 to the center SCSI