Specifications

Chapter #4 - Overview - NAS 6000 Disk Array 130 000001628
MaxAttach NAS 6000 Administration Guide
Chapter #4 - Overview - NAS 6000 Disk Array
Re-Configuring Your MaxAttach NAS 6000 Drive Arrays
11/07/01 -- Revision 2.0.03A
n If you want to reconfigure drive H:\, you must first disassemble drive J:\, then
drive I:\, and finally drive H:\. The disassembly process takes the drives out of
their previous arrays and leaves them in the system with an “unconfigured
status.”
n During this process, all user data on the array is destroyed.
n At this point, you can now reconfigure drive H:\ into a new configuration.
n Then you would have to reconfigure drive I:\ to its original configuration
followed by reconfiguring drive J:\.
12. Once the drive arrays have been reconfigured, use the Max O/S Web User Interface
(UI) to reconfigure network, users, group, folder, and share option.