Specifications

Chapter #4 - Overview - NAS 6000 Disk Array 117 000001628
MaxAttach NAS 6000 Administration Guide
Chapter #4 - Overview - NAS 6000 Disk Array
Standard Disk Array Configuration
11/07/01 -- Revision 2.0.03A
2. At the Welcome page, click on the Status tab on the main navigation bar.
3. At the Status menu, click the System Status tab.
4. The system displays the following information:
n Number of physical disks:
• This is actually the number of Volumes or Logical Drives
available in the system.
• In default RAID configuration, it will be four drives for
a Base Unit only; six drives for a Base and one Expansion
Unit;, eight drives for a Base and two Expansion Units.
n Total hard disk drive space:
• The amount of space in your system in GB (Gigabytes or
Gbyte - 1,000 Gbytes = 1 Tbyte).
n Total free hard drive space:
• The amount of free space in your system in GB.
To see total system space for each volume or logical drive
1. Log into the system.
2. At the Welcome page, click on the Status tab on the main navigation bar.
3. At the Status menu, click the System Health tab.
4. Scroll down about a two pages to the status Drives section.
5. The system displays the following information in a table:
n Device ID:
• The volume or logical drive identification starting with
C:\.
• A fully factory-default configured system will have C:\,
D:\, E:\, F:\ G:\, H:\, I:\ and J:\ drives.
n Drive capacity:
• The total drive capacity per drive in GB.
n Free space:
• The total drive free space in GB.
n Used space:
• Used space as a percentage of total space.