Operating instructions

Video Web Server Features
• Compatible with most of CCTV Products; empower any video output device watching and
controlling on the Internetor LAN
• Auto Network Reconnection (ANR)
• Upgrade firmware & AP from FTP site via Video Web Server
• Support Watch dog function
• Support Dynamic IP address via a router.
• Support 4 alarm inputs
• Duplex function, record and playback simultaneously at client site
• Auto e-mail warning system which will remind you if external alarm
happens
• Intelligent non-stoppable recording function after ANR
• Support Multi AP screens Unique video player
• Alarm trigger recording function.
1 ) Connect the Sub-D plug of Video Web
Server with our own brand DVR products.
2 ) Set the “Remote” function in the DVR
products.
NOTE : Remote mode : RS-485,
Baud rate : 2400, ID : same
as “I/O port setting” in the Video
Web Server.
3 ) Set the “I/O Port Setting” in the system
configof Video Web Server.
Port1 : 4CH DVR, Device ID : 001.
DVR Control
Video Web Server
APPENDIX E– NETWORK APPLICATION
38
GND
ALARM
INPUT1
NORMAL
LOW
NORMAL
HIGH
RS485-A
RS485-B
ALARM
INPUT2
ALARM
INPUT3
ALARM
INPUT4
RS232-TX
GND
RS232-RX
RE485-B
ALARM INPUT1
RS485-A
ALARM INPUT2
DISK FULL
ALARM INPUT3
REC START
ALARM INPUT4
ALARM RESET
EXTERMAL ALARM NC
EXTERNAL ALARM COM
EXTERNAL ALARM NO
Video Web Server 4CH DVR