Operating instructions

3. LS (Level Sensitivity)

Comparing the difference between two images to allow the system to start motion detection function.

Lower number = higher sensitivity for motion detection. The highest sensitivity setting is 0,

the lowest sensitivity setting is 15. The default value is 06.

4. SS (Spatial Sensitivity)

Set the number of motion detection targets (from 1-99 target areas). The highest sensitivity setting is 0, the

lowest sensitivity setting is 15. The default setting is 01.

Note:The setting of Spatial Sensitivity cannot be more than the number of targets set in the AREA.

5. TS (Temporal Sensitivity)

The system will start the motion detection function if the continuous fields are all different.

The highest sensitivity setting is 0, the lowest sensitivitysetting is 15. The default setting is 01.

6. RE (Reference)

Set the Reference image to which the current screen is compared (from 0-63).

For example, the value 8 would compare the current image tothe 8

previous image. The higher

value will increase the sensitivity. The default value is 10.

7. ALARM

Select LOW / OFF / HIGH for alarm polarity. The default alarm value is OFF.

8. EVENT DURATION

Set the event duration time.

9.DAY. START. END of Detection

Choose the day for recording, the beginning of recording time and the end of recording time.

Note: When the motion detection function is triggered during the recording period. The symbol will be shown .

When the alarm function is triggered during the recording period. The symbol will be shown .

▲▼ : navigates between targets.

- :turns all targets on the screen ON/ OFF.

+ : press once to set a motion target, press twice to set a row of motion target.

▼