User manual

3.10.4 Press “ SLOW “ button to setup the Sensitivity list up to 255

Press “ REC “ button to setup the Sensitivity list down to 000

Sensitivity value is related to motion and brightness change.

Low value (as 001) means higher sensitivity on motion and brightness change.

High value (as 255) means lower sensitivity on motion and brightness change.

User can choose the suitable sensitivity value in different locations.

The default value is set on 32.

Note:

If Motion Detection is set, and when activated, there will be two actions as follows:

1). Live video - the motion detected camera(s) will be scanned more frequently, if the Video

setup is for 16 cameras, the sequence to scan the cameras are from 1st, 2nd, 3rd... until 16th

camera, but if the motion is detected on Camera #1, the sequence to scan #1 camera will be

more frequently. It will be scanning as 1st, 2nd, 1st, 3rd, 1st, 4th...1st, 16th.

The motion-detected camera will be scanned more frequently, which will be one after another

camera been detected. If the 2nd and 3rd camera both motion detection are activated, they will

be scanning as 1st, 2nd, 3rd, 2nd, 2nd, 3rd, 3rd, 2nd, 3rd, 4th, 2nd, 3rd....3rd, 16th, 2nd, 3rd

and vice versa.

2). Recorded Video - more frequently video will be recorded for the motion detected cameras,

the function is the same as Live video in the above mentioned.

Basically, the motion detection will only change the scanning sequence while in live mode or in

Record mode. It doesn’t show any sign on the monitor and it cannot automatically change the

mode from Standby Mode to Record Mode.

Figure 1 MOTION DETECTION SETUP

2 3 4 5 6 7 8 9 10

12 13

032