User manual

19
3.5.5 DWELL TIME setup
This setting allows the user to set the DWELL TIME. DWELL TIME is the length of time
that each channel is sequentially shown on the CALL monitor output.
3.5.5.1 Press ” Up” or “ Down” to choose DWELL TIME setup.
3.5.5.2 Press ” ENTER” to confirm DWELL TIME setup.
3.5.5.3 Press ” Up” or “ Down” to choose DWELL TIME setup.
01~10 SEC.
3.5.5.4 Press ” MENU” to exit and confirm the current operation.
3.5.5.5 Press ” MENU” again to exit and close SYSTEM setup mode.
3.5.6 MESSAGE LATCH setup
This setting allows the user to decide whether the External Alarm graph is displayed on
the monitor or not.
3.5.6.1 Press ” Up” or “ Down” to choose MESSAGE LATCH setup
3.5.6.2 Press ” ENTER” button to confirm MESSAGE LATCH setup
3.6.6.3 Press ” Up” or “ Down” to choose the MESSAGE LATCH : ON/OFF
ON : Message latch ON
OFF : Message latch OFF
3.6.6.4 Press ” MENU” to exit and confirm the current operation.
3.6.6.5 Press ” MENU” again to exit and close SYSTEM setup mode.
3.5.7 TITLE DISPLAY setup
This setting allows the user to set whether the title is shown on the monitor or not.
3.6.7.1 Press ” Up” or “ Down ” to choose TITLE DISPLAY setup
3.6.7.2 Press ” ENTER” button to confirm TITLE DISPLAY setup
3.6.7.3 Press ” Up” or “ Down ” to choose TITLE DISPLAY : ON/OFF
ON : Title Display ON
OFF : Title Display OFF
3.6.7.4 Press ” MENU ” to exit and confirm the current operation.
3.6.7.5 Press ” MENU ” again to exit and close SYSTEM setup mode.