User`s manual

ARS-2016/2016EB Manual

Before connecting an IDE hard drive to the cabinet, you have to power off the sys-

tem, then follow the steps below to connect.

Step 1: Insert the enclosed plastic stick into the loophole to loosen the handle.

Step 2: Hold the handle to pull out the cabinet.

Step 3: Connect the IDE cable and 4-pin power connector to the IDE hard drive.

Step 4: Screw the hard drive, and replace the cabinet.

Step 1

Step 2

loophole

4-pin power connector

pin 1 of the IDE cable

Step 3

Step 4

Figure 4-6

Figure 4-7

NOTICE: The handle is a switch to control the hard drive power, so do

not open it arbitrarily during operation.