User`s manual

ARS-2016/2016EB Manual

Follow the steps below to connect an IDE hard drive to the cabinet.

Step 1: Insert the plastic stick into the loophole to loosen the handle.

Step 2: Hold the handle to pull out the cabinet.

Step 1

Step 2

Figure 4-2

loophole

NOTICE: The handle is a switch

to control the hard drive power, so

do not open it arbitrarily during

operation.

Step 3: Connect the IDE cable and 4-pin power connector to the IDE hard drive.

Step 4: Screw the hard drive, and replace the cabinet.

Step 3

Step 4

4-pin power connector

pin 1 of the IDE cable

Figure 4-3