User`s manual

DVR200 Series User’s Manual
30
3.6.8 Per Channel Config
This menu is used to configure the <Video Loss Detect>, <Motion Detect>,
<Alarm In> and <Alarm Out> settings for each channel. The menu is
displayed as below.
Per Channel Config
Channel Select
Video Loss Detect
Motion Detect
Detection Config
Alarm In
Alarm Out
CH01
Off
Off
ENTER
OFF
OFF
3.6.8.1 Channel Select
The item is used to select a desired channel for setting the parameters. Move
the cursor to <Channel Select> and press ENTER, then select a channel
using UP / DOWN keys. Press ENTER again to confirm the selection.
3.6.8.2 Video Loss Detect
This item allows users to enable or disable Video Loss as an alarm event.
Select <On> to enable Video Loss alarm events, or <Off> to disable.
3.6.8.3 Motion Detect
This item allows users to enable or disable motion detection function of the
DVR. Select <On> to enable Motion Detect alarm events, or <Off> to disable.
If motion detection function is enabled, it is required to define motion
detection parameters such as detection area and sensitivity settings in
<Detection Config>.
3.6.8.4 Detection Configuration
If motion detection function is enabled, it is required to define the motion
detection parameters such as detection area and sensitivity settings. Select a
channel for setting the parameters, move the cursor to <Detection Config>
and press ENTER. The Detection Configuration menu displays as follows.
Detection Config
Detected Area Setup
Sensitivity
Block Threshold
ENTER
88%
4