Specifications

INSTALLATION
4 – 23
Drive Jumper Settings
Figure 4-4 shows the valid jumper settings for the Maxtor hard drive.
A spare jumper shunt is shipped between J46 and J48.
Mounting Drive in System
Turn the computer OFF, disconnect the power cord and remove the cover. Refer to your computer user’s manual for
additional information.
Installing 5.25-inch Mounting Brackets
Mounting brackets are only needed when the drive will be installed in a 5.25-inch drive bay. This step is not necessary when
installing the drive in a 3.5-inch bay. See Figure 4-5 below.
Mounting Rails
Mounting rails are attached to the mounting bracket for systems requiring this feature. See Figure 4-5 below.
Figure 4 - 4
Master/Slave Jumper Detail
Figure 4 - 5
5.25-inch Mounting Brackets/Slider Rails