User`s manual

9
5. START UP
5.1 PRE-CAUTIONS
z You are firmly requested to turn off the power only in
Setup mode of the MENU. Forced disconnection of
Power supply in Record mode can cause malfunction
of HDD.
5.2 BOOTING (FIRST SCREEN)
z Plug in the Power Supply. If power is properly
connected, the system will start booting. It takes about
30 seconds to boot and display the first screen. The
screen is recording screen mode.
z Before the initial operation, you must set Time/Date,
set FACTORY DEFAULT, and then clear HDD, even
though it is brand new one. It is to make the DVR and
HDD ready for proper operation. Starting recording
without FACTORY DEFAULT setting and HDD clear
will cause malfunction. FACTORY Refer to ‘SETUP’
for getting how to proceed with DEFAULT setting and
HDD clear.
6. SETUP
6.1 SYSTEM MENU
z Press MENU key to enter the SYSTEM MENU and
you will see as below.
z Enter password with Channel Number key from No.1
to No.10 on the front of the DVR unit. (Maximum of 8
digits are available)
z Factory default password is blank. For log-in, just
press MENU key and then ENTER key.
z Administrator: If the password entered matches
previously set password, ‘LOGIN ADMIN’ message
appears and you can enter into SYSTEM SETUP. If
the password entered does not match previously set
password, the DVR unit goes back to live display
mode.
z Factory default passwords are as below.
- ADMIN: Blank (ENTER key)
- MANAGER: ‘ 1 ’
- USER 1~USER 8: ‘ 2 ’ ~ ’ 9 ’
z Put in correct Password and press ENTER key to
display SYSTEM MENU as below.
6.2 DISPLAY SETUP
z Select DISPLAY SETUP and press ENTER key will
show as below.
6.2.1 Screen Display
z Setting up the screen display in LIVE mode and
PLAYBACK mode.
z Select the sub-menu which you would like to set using
▲▼ keys and then change ON/OFF with ENTER key.
- TIME/DATE: Display time & date.
- ICON DISPLAY: Display function setting status.
- DVR STATUS: Display system setting status.
- REC / PLAY BAR: Display record / playback status.
- CAMERA TITLE: Display camera title.
6.2.2 Monitor Setup
z VGA SETUP: VGA option card enables to connect
TFT LCD monitor or CRT type PC monitor to DVR
unit. To connect TFT LCD monitor or CRT type PC
monitor to DVR unit, select resolution as follows using
[+] [−] keys. After setting the below option, press
ENTER key then the DVR unit will set VGA resolution
automatically. VGA option card supports following
resolution, and choose best resolution that
match TFT LCD monitor or CRT type PC monitor to
SYSTEM MENU
DISPLAY SETUP
CONFIGURATION
RECORD SETUP
BACK-UP
EXTERNAL DEVICE
FACTORY DEFAULT
LANGUAGE ENGLISH
LANGUAGE SELECT: + -
SELECT MENU : ▲▼
,
&
[
ENTER
]
DISPLAY SETUP
SCREEN DISPLAY
MONITOR SETUP
SELECT MENU : ▲▼
,
&
[
ENTER
]
DVR LOG-IN
ENTER PASSWORD
_ _ _ _ _ _ _ _
INPUT YOUR OWN PASSWORD
TO EXIT, PRESS [MENU]