- Max user guide Transceiver

50
Technical Information
Specifications
W eight: 5.4 ounces with alkaline batteries
Dimensions: 1.4 inches deep x 2.1 inc hes wide x 4.0 inches tall (body only)
Flexible antenna = 2.4 inches tall. 0.3 inches in diameter
Batteries: 2 x AA (IEC:LR6), 1.5 V batteries, alkaline recomm ended
Read the Getting Started section, Page 13, for more inform ation
AC Adapter Jack: 3 VDC unregulated, 0.3 A (300 milliamp) or higher
4.5 VDC regulated, 0.2 A (200 milliamp) or higher, (recommended
)
Polarity = c enter positive, ou tside negative
Male plug specifications: 1.3mm ID, 3.4mm OD, 1cm long
Input / Output Ports:
Size 3.5mm (1/8") mono miniphone
Maximum Input Voltage 250 VDC
PORT 1 current handling 0.5 A (½ Amp), current limited
PORT 2 current handling 4.0 A for 0.00002 seconds (1/50000 second
or 20 microseconds)
0.25 A (1/4 Amp or 250 milliamp) continuous,
current limited
PO RT 1 polarity tip positive, non-reversible
PO RT 2 polarity tip positive, reversible
PO RT 1 and Hot Shoe
Voltage present
3.3 VDC, 0.001 A (1/1000 Amp or 1 milliamp),
regulated
PO RT 1 and Hot Shoe
triggering threshold
< 2.2 V
PO RT 1 and Hot Shoe
holding current
0.0005 A (1/2000 Amp or 50 microamps)
HOT SHOE NOTE #1: PORT 1 and the hot shoe are electrically connected together.
A device attached to PORT 1 will trigger when the TRANSMIT unit is triggered by the
hot shoe. This is not controllable by the L key. While the device may trigger in sync
with the shutter, it will not be controlled by the MultiMAX. If the device is a high
voltage flash unit then the MultiMAX does not provide voltage protection to the camera
in this situation. For normal operation do not use PORT 1 to trigger a high voltage
flash on a TRANSMIT unit unless nothing is attached to the hot s hoe.