- Max user guide Transceiver

33
Rear Curtain Screen
B: Remotes Only – ~/MENU A A B
Enters the numeric entry screen. Delays the Radio remote units only. PORT 2 will
trigger immediately. Remote units will trigger after the displayed delay. If the contact
time for the MultiMAX (set for TRAN SM IT mode) is longer than the delay, PORT 2 will
remain contacted for the delay time rather than the contact time.
C: Rear Curtain
– ~/MENU A A C
Enters the Rear C urtain screen. Use this mode to
trigger the flash at the end of an exposure rather than
at the beginning. In this mode both the Radio remote
trigger and PORT 2 are delayed.
Use the  keys to set the rear curtain sync time
equal to the camera’s shutter speed. Common rear
curtain sync times are available per the table below:
Rear C urtain
Sync Time
Decimal
Equivalent
Actual Delay
Used
1/1 1 second 0.98 seconds
½ 0.5 seconds 0.49 seconds
¼ 0.25 seconds 0.24 seconds
1/8 0.125 seconds 0.119 seconds
1/15 0.0667 seconds 0.062 seconds
1/30 0.0333 seconds 0.029 seconds
1/60 0.0167 seconds 0.014 seconds
L For rear curtain sync times other than the ones displayed above, or for fine tuning
rear curtain times for your specific equipment, press ~/MENU to return to the main
screen. Press ~/MENU A A A (see the section A:Delay Remotes + PORT 2
,
Page 32) and adjust the delay number as needed.