- Max user guide Transceiver

17
Triggering M ultiple Flashes With M ultiple RECE IVE Units
Multiple remote flash units may be triggered in sync with each other.
1. Install batteries in each additional MultiMAX unit
2. Use flash cable to connect each additional flash unit’s sync terminal to
FLASH / PORT 2
3. Set power switch on each additional MultiMAX unit to RECEIVE mode
4. Set all MultiMA X un its to s ame channel as T RAN SMIT unit
You’re all s et! Use the camera norm ally.
Connecting MultiMAX (set for TRANSM IT mode) to Flash
A flash can be connected to a MultiMAX (set for TRA NSMIT mode). It will trigger in sync
with the remote flash units. T his flash is called the local flash and is usually mounted
on a camera bracket.
1. Use a flash cable to connect the flash unit’s sync term inal to FLASH / PO RT 2 of
the MultiMAX (set for TRANSMIT mode)
2. Use the L key to enable or disable the Local flash
You’re all s et! Use the camera norm ally.
L Using a local flash this way protects the camera from high voltages. See the
Specifications section, Page 50, for more information.