Product manual

XStream‐PKG‐T™TelephoneRFModem–ProductManualv5.x00[2006.02.24]
CF (Connection Failure Count) Command
<Diagnostic> Set/Read the number of times the
base module expired retries attempting to send a
Connection Grant Packet. Set to zero to clear the
register.
AT Command: ATCF
Binary Command: 0x34 (52 decimal)
Parameter Range: 0 – 0xFFFF
Default Parameter Value: 0
Number of bytes returned: 2
Minimum Firmware Version Required: 4.30
CL (Last Connection Address) Command
<Diagnostic> Read the address of the remote
module that last connected to the base module. A
remote module will return its DT (Destination
Address) parameter.
AT Command: ATCL
Binary Command: 0x39 (57 decimal)
Parameter Range: 0 – 0xFFFF [read-only]
Number of bytes returned: 2
Minimum Firmware Version Required: 4.30
CM (Connection Message) Command
AT Command: ATCM
Binary Command: 0x38 (56 decimal)
Parameter Range: 0 – 1
Parameter Configuration
0 enable
1 disable
Default Parameter Value: 0
Number of bytes returned: 1
Minimum Firmware Version Required: 4.30
<Networking> Select whether base sends
connect messages to the host when a connection
is established. When enabled, a “CONNECTXXXX”
string is sent to the host of the base module.
“XXXX” is the MY (Source Address) of the
connected remote module.
CN (Exit AT Command Mode) Command
<AT Command Mode Options> CN Command is
used to explicitly exit AT Command Mode.
AT Command: ATCN
Binary Command: 0x09 (9 decimal)
CO (DO3 Timeout) Command
<Serial Interfacing> DO3 output will return to
default after no DI3 status information is received
during the timeout period.
AT Command: ATCO
Binary Command: 0x2E (46 decimal)
Parameter Range: 0 – 0xFFFF [x 1 second]
Default Parameter Value: 3
Number of bytes returned: 2
Related Commands: CD (DO3 Configuration),
DR (DI3 Configuration)
Minimum Firmware Version Required: 4.30
Use with CD = 1 or 2. DR =1.
©2006MaxStream,Inc.,ConfidentialandProprietary 48

www.agelectronica.com www.agelectronica.com
www.agelectronica.com www.agelectronica.com