Product manual

XStream‐PKG‐T™TelephoneRFModem–ProductManualv5.x00[2006.02.24]

RF Module Configuration

X-CTU Software

X-CTU software can be used to setup and monitor XStream-PKG-T RF Modems communications.

The software provides an easy-to-use interface that is divided into four tabs.

• PC Settings tab - Setup PC serial com ports to interface with XStream RF Modem

• Range Test tab – Test Modem Range

• Terminal tab – Configure and read XStream RF Module & Telephone Module parameters

• Modem Configuration tab – DO NOT USE when configuring the XStream-PKG-T RF Modem.

The “Modem Configuration” tab is used to configure XStream RF Modules that are mounted

to the XIB-R (RS-232/485) and XIB-U (USB) Interface Boards.

To Install X-CTU Software:

1. Double-click the “setup_X-CTU.exe” file then follow prompts of the installation screens. This

file is located in the “software” folder of the MaxStream CD and under the ‘Downloads’

section of the following web page: www.maxstream.net/support/

FigureB‐03. TerminaltaboftheX‐CTUSoftware(UsedtoconfiguretheTelephoneandRFModules

