User Manual

3
MOUNTING TO A FLAGPOLE
To mount on a agpole, position the agpole mounting
bracket supplied against the agpole and run the two
supplied metal bands through the bracket as shown.
*CAUTION: Do not tighten the metal bands until your Solar
Powered Flood Light is where you want it as they cannot
be re-opened. Put the bracket up to the pole and close
the metal bands around the pole, making sure the bands
are pulled tight so the light is firmly secured.
TO MOUNT THE SOLAR PANEL TO A WALL OR ROOF
The solar panel can be mounted to a wall or roof, set on the ground, or attached directly
to the light.
Use the four (4) wood/sheet metal screws supplied to mount the solar panel onto a solid
surface. You can adjust the angle of the solar panel by gently rotating it to a different
locking position. Remember to mount the panel facing South, which will maximize the
direct sunlight exposure.
TO MOUNT THE SOLAR PANEL TO THE LIGHT
This can be very helpful if you want to mount the product to a sign. You will find two bolts
protruding from the body of the light. Line up these bolts with the two mounting holes on
the bottom side of the trapezoid that makes up the mounting base of the solar panel.
Push the solar panel base onto these bolts until it is against the surface of the light. Use
the included lock-washers and nuts to tighten the solar panel in place.
Once you have mounted the solar panel in the
desired location, connect the solar panel to your
Solar Powered Flood Light by plugging the 10 foot
cord into the cord attached to the bottom of the
Solar Powered Flood Light. Firmly turn and twist the
cords while pressing together for a tight connection.