Installation Manual
3
MOUNTING TO A FLAGPOLE
To mount on a agpole, position the agpole mounting
bracket supplied against the agpole and run the two
supplied metal bands through the bracket as shown.
*CAUTION: Do not tighten the metal bands until your Solar
Flood Light is where you want it as they cannot be re-
opened* Put the bracket up to the pole and close the metal
bands around the pole, making sure the bands are pulled
tight so the light is rmly secured.
TO MOUNT THE SOLAR PANEL TO A WALL OR ROOF
The solar panel can be mounted to a wall or roof, set on the ground, or attached directly
to the light.
Use the four (4) wood/sheet metal screws supplied to mount the solar panel onto a solid
surface. You can adjust the angle of the solar panel by gently rotating it to a different
locking position. Remember to mount the panel facing South, which will maximize the
direct sunlight exposure.
TO MOUNT THE SOLAR PANEL TO THE LIGHT
You will nd two bolts protruding from the body of the light. Line up these bolts with the two
mounting holes on the bottom side of the trapezoid that makes up the mounting base of the
solar panel. Push the solar panel base onto these bolts until it is against the surface of the
light. Use the included lock-washers and nuts to tighten the solar panel in place.
Once you have identied all parts, connect the solar
panel to your Solar Powered Flood Light by plugging
the 9 foot cord into the cord attached to the bottom of
the Solar Flood Light. Firmly turn and twist the cords
while pressing together for a tight connection.