Specifications

MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide 89
6) Gently lift the power supply out of the system as illustrated in Figure 5-93.
Figure 5-93
7) Take the new main power supply unit supplied by MaxVision support and incorporate it into the
system by performing the steps described above in reverse order.
Motherboard
Replacing the motherboard is non-trivial. It is easy to damage the motherboard unless one has the
appropriate tools and training. For this reason, you must either return the MaxPac system to
MaxVision or be factory trained by MaxVision personnel (see Appendix D for more details about
contacting MaxVision support and returning your MaxPac to MaxVision).
Note: Certain components can be replaced without removing the inner chassis from the outer
chassis. Some of these components include memory, main power supply, PCI and PCI Express
boards. While it is fairly easy to remove the inner chassis for the Single-Display XRA1 it is more
difficult for the Dual/Triple-Display XRA2/3. Some photos will include the outer chassis while others
will not.
1) Open the display assembly into its service position as discussed earlier in this chapter.
2) Remove any PCI and PCI Express cards as discussed earlier in this chapter.
3) Remove the Power Distribution Board as detailed earlier in this chapter.
4) In order to replace the motherboard, you must first remove the inner chassis. In order to do this,
the display power cables, display data cables and soft power cable must be disconnected.
Figure 5-96 Figure 5-97