Specifications

88 MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide
4) Disconnect the ATX 24-pin power connector from the motherboard. Pull the connector up while
using a flat-blade screwdriver to push the top of the release catch (facing the bottom of the
chassis) into the body of the connector (Figures 5-87 and 5-88).
Figure 5-87 Figure 5-88
5) Use a Phillips #2 screwdriver to remove the four screws attaching the power supply unit to the
side of the inner chassis (Figures 5-89 through 5-92).
Figure 5-89 Figure 5-90
Figure 5-91 Figure 5-92
Note: Observe the way in which the inner chassis is lifted in Figures 5-90 and 5-91 so as to
facilitate access to two of these screws.