Specifications

84 MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide
Optical Drive (CD/DVD) Backplane
Note: The CD/DVD backplane cannot be easily replaced without first removing the main Power
Supply Unit (PSU). In the rare case that support advises that the CD/DVD backplane needs
replacing refer to the section on the PSU later in this chapter and then return to this section..
1) Open the display assembly into its service position as discussed earlier in this chapter.
2) Remove the CD/DVD drive as discussed in the previous topic.
3) Remove the ATA cable (observing where the red stripe is for future reference) as illustrated in
Figure 5-70.
Figure 5-70 Figure 5-71
4) Remove the main power connector as illustrated in Figure 5-71 (release the latch with your finger
or thumb nail while pulling ion the cable).
Figure 5-72 Figure 5-73
5) Remove the CD/Audio cable as illustrated in Figure 5-72.
6) Use a Philips #1 screwdriver to remove the two screws attaching the CD/DVD backplane to the
main chassis as illustrated in Figure 5-73
7) Gently remove the CD/DVD backplane as illustrated in Figure 5-74.
8) Present the replacement CD/DVD backplane supplied by MaxVision support to the inner chassis
and perform the steps described above in reverse order.