Specifications

MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide 75
2) In order to remove and replace a memory stick, gently press down-and-out on the two plastic
“rabbit-ears” at either side of the stick which will cause it to pop out, and then remove the stick
from the system (Figure 5-34).
Figure 5-34 Figure 5-35
3) Observe that the memory sticks are keyed such that they can only be inserted one way. Take the
new (replacement) memory stick sent to you by MaxVision support and gently press it down into
the original slot on the motherboard.
4) Return the system to its initial condition by reversing the order of the operations discussed at the
beginning of this section.
PCI Cards (General)
1) Open the display assembly into its service position as discussed earlier in this chapter.
2) If you are replacing an existing PCI card, use a Phillips #2 screwdriver to remove the 6-32 screw
attaching the card’s retaining bracket to the inner chassis as shown in Figure 5-36. (If you are
adding a new card, remove the corresponding blanking plate screw.)
Figure 5-36 Figure 5-37
3) Gently pull out the old card as shown in Figure 5-37.
4) This particular example features a SATA RAID controller card. In this case, you also need to
disconnect the data cables from the card as shown in Figure 5-38 (see notes below).