Specifications

MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide 69
Figure 5-13 Figure 5-14
2) Use a Phillips #2 screwdriver to remove the eight 6-32 1/4" black countersunk screws – four on
each site – holding the screen to the wing brackets, which are in turn attached to the main
chassis (Figure 5-14).
3) Lift the center screen into a vertical position standing against the cable-side pair of wing brackets
as illustrated in Figures 5-15 and 5-16 (as these monitors are expensive items, it is recommended
that you keep hold of the screen when it is in this vertical position).
Figure 5-15 Figure 5-16
4) On the other side of the screen (with regard to Figure 5-16), observe the monitor tilt-stand
components lying in/on the main chassis as indicated by the pointing finger in Figure 5-17. It is
very important to ensure that these components remain flat and interleaved.