Specifications

44 MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide
memory (which can theoretically be up to 128 GB) and all of this memory will be available to the
applications.
1) Open the display assembly into its service position as discussed earlier in this chapter.
2) In order to remove and replace a memory stick, gently press down-and-out on the two plastic
“rabbit-ears” at either side of the stick which will cause it to pop out (Figure 4-44), and then
remove the stick from the system (Figure 4-45).
Figure 4-44 Figure 4-45
3) Observe that the memory sticks are keyed such that they can only be inserted one way. Take the
new (replacement) memory stick sent to you by MaxVision support and gently press it down into
the original slot on the motherboard.
4) Return the system to its initial condition by reversing the order of the operations discussed at the
beginning of this section.
PCI Cards (General)
1) Open the display assembly into its service position as discussed earlier in this chapter.
2) If you are replacing an existing PCI card, use a Phillips #2 screwdriver to remove the 6-32 screw
attaching the card’s retaining bracket to the inner chassis as shown in Figure 4-46. (If you are
adding a new card, remove the corresponding blanking plate screw.)
Figure 4-46 Figure 4-47